Easy operation for tin cure silicone rubber using for molds

Guochuang-inner-page-design-blog-1

Following the below steps. it is easy to make your moulds:

  1. Prepare and clean the prototype.
  2. Mixing part A and part B evenly. Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly.
  3. Vacuum pumping. Without exception, this step takes less than 10 minutes.
  4. Pouring cast or brushing cast. After released the bubble, we can pour/brush the silicone rubber on the prototype
/by