1.Good characteristics of easy-operation
2.Light viscosity and good flowability
3.Low shrinkage
4.Favourable tensile and tear strength
5.High-temperature resistance, acid and alkali-resistance
6.High duplication times
7.Vulcanize at room temperature
8.Easy for demoulding
9.No smell ,non-flammable ,safe and reliable
| Item | Parameter | ||||
| C-825 | |||||
| Viscosity(cps) | 20000±500 | ||||
| Hardness(A°) | 25±2 | ||||
| Tensile Strength(kgf/cm²) | 40±2 | ||||
| Tear Strength(KN/M) | 24±1 | ||||
| Elongation(%) | 450±50 | ||||
| Shrinkage Rate(%) | 0.3% | ||||
| Mixing Ratio | 100:2 | ||||
| Life Time(Min) | 20~30 | ||||
| Curing Time (hr) | 2~3 | ||||
| Temperature(℃) | 25 | ||||
Making molds for
Step One: Prepare and clean the prototype. You must make sure your original moulds perfect.
Step Two: Mixing part A and part B evenly. Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly.
Step Three: Vacuum pumping. Without exception, this step takes less than 10 minutes. Otherwise, it will cause a cross-linking reaction, and no further steps will be available.
Step Four: Pouring cast or brushing cast. After released the bubble, we can pour/brush the silicone rubber on the prototype
Pouring cast:
It is suitable for simple products with a smooth surface. Without any mould lines, which helps you save time and is easy for operation. Evenly and slowly pouring the mixed silicone rubber into the square frame. After the cross-linking reaction and the silicone rubber turns dry, you can take the products out. Thus, the mould has been done.
Brushing cast:
1. It is a kind of non-dangerous goods. This product should be sealed and placed in a cool and dry place which should keep from sunlight and rain .
2. Especially note that the silicone should not touch or mix with compounds including nitrogen, phosphorus, sulfur, tin, lead or metal organic acid.
3. Addition cure Silicone RTV-2 is an environmentally-friendly liquid silicone product is not easy to burn which can be stored and transported as non-hazardous goods.
4. The shelf life is 12months from the date of production.
It can be reused after reinspection when it exceeds the storage period.
the tin cure rtv2 mold making silicone rubber is high tensile and tear strength ,high temperature resistance ,acid and alkali-resistance and high duplication times for mold making
high quality rtv-2 mould making silicone rubber for concrete plaster decora... 
: sunnyzhousan
: 86-13925729510
: 86-13925729510
: